Input, Midstage, And Output Pads - Motorola STARLINE SERIES Installation And Operation Manual

3-6 Amplifier Setup
The information in Table 3-2 is shown as a graph in Figure 3-2:
Figure 3-2
Frequency versus cable slope
0
-1
-2
-3
-4
-5
-6
-7
-8
-9
-10
-11
-12

Input, Midstage, and Output Pads

Install model JXP-*B pads to attenuate the signal per system design drawings. Generally, this
consists of attenuating excessive input levels. You should pad the input to system level for unity
gain. Select and install the specified pad in the socket labeled
The midstage pad (JXP) and output pads (JXP2 and JXP3/4) can be used to adjust the gain level
and achieve the gain specification. Refer to Section 6, " Operating Tips" for midstage/output
padding information and recommendations.
MB*/* Installation and Operation Manual
Frequency (MHz)
JXP
SCS-1
SCS-2
SCS-3
SCS-4
SCS-5
SCS-6
SCS-7
SCS-8
SCS-9
SCS-10
- on the amplifier cover.
IN