Motorola Signal Booster Installation Manual

Signal Booster Installation Guide
To install the Signal Booster, perform the following steps and refer to the drawing below:
1. Connect the cable from your cable service provider or antenna (cable in) to the Signal Input on
the Signal Booster. (In typical installations, the input cable is already connected to the television
or VCR. Disconnect this cable and connect it to the Signal Input on the Signal Booster).
2. Connect the Signal Output on the Signal Booster to the television or VCR input using the supplied
6 foot coaxial cable.
3. Use the other 6 foot coaxial cable to connect the ac adapter to the Power 12 Vdc connector on
the Signal Booster.
4. Plug the ac adapter into a convenient wall outlet. The lighted, green LED confirms that power is
correctly applied.
You can mount the Signal Booster to any suitable indoor surface using the screws provided, or it may lay
flat.
(Step 4)
120 Vac in,
12 Vdc out
adapter
(Step 3)
If You Need Help
If you need assistance while working with the Signal Booster, call Motorola's Customer Service and
Technical Support Center at 1-877-466-8646.
6 foot
coaxial
cable
Power 12 Vdc
Broadband Drop Amp
52-1000 MHz Fwd (+15dB)
5-40 MHz Rtn (-1dB)
Signal Output
(Step 2)
6 foot coaxial cable out to
televisions/set-top terminals
Cable in
(Step 1)
F-type
connector
Signal Input
Part Number: 484095-001-00
M O TOR OL A and th e Stylized M L ogo are
re gis tere d trade m arks o f M oto ro la, Inc.
® Re g. U.S . Pa t. & Tm . O ff.
© 200 1 Moto ro la ,In c. A ll righ ts re served .
M ad e in Taiw an