Input, Midstage, And Output Pads - Motorola BT100 Installation And Operation Manual

3-6 Amplifier Setup
The information in Table 3-2 is shown as a graph in Figure 3-2:
Figure 3-2
Frequency versus cable slope
1
0
-1
-2
-3
-4
-5
-6
-7
-8
-9
-10
-11
-12
-13

Input, Midstage, and Output Pads

Install model JXP-*B pads to attenuate the signal per system design drawings. Generally, this
consists of attenuating excessive input levels. You should pad the input to system level for unity
gain. Select and install the specified pad in the socket labeled
The midstage pad (JXP) and output pads (JXP OUT, JXP 1, JXP 3, and JXP 4) can be used to
adjust the gain level and achieve the gain specification. Refer to Section 6, "Operating Tips" for
midstage/output padding information and recommendations.
BT100 Installation and Operation Manual
Frequency (MHz)
JXP IN
SCS-1
SCS-2
SCS-3
SCS-4
SCS-5
SCS-6
SCS-7
SCS-8
SCS-9
SCS-10
on the amplifier cover.