Table of Contents
Advertisement
Installation
Warning!
Unpacking
Slide out the polythene bag with the
polystyrene stuffing before using the
appliance.
Pull off adhesive strips from inside machine on
top of drum
Should the appliance be moved, it must be
transported vertically.
Positioning
It is recommended for your convenience, the
machine is positioned close to your washing
machine.
The tumble dryer must be installed in a clean place,
where dirt does not build up.
Air must be able to circulate freely around the
appliance. Do not obstruct the front ventilation grille
or the air intake grille at the back of the machine.
Keep the vibration and noise to a minimum. When in
use the dryer should be placed on a firm, level
surface.
Once the dryer is on its permanent operating
positioning, check the dryer is level with the aid of a
spirit level. If it is not, raise or lower the levelling
feet.
The feet must never be removed.
Do not restrict the floor clearance through deep
pile carpets, strips of wood etc. This can cause
heat build up which can interfere with the
operation of the appliance.
Important
The hot air emitted by the tumble dryer can reach
temperatures up to 60°C. The appliance must not
be installed on floors which are not resistant to high
temperatures.
When operating the tumble dryer, the room
temperature must be no lower the 5°C and no
higher than 35°C. This can affect the performance
of the dryer.
Electrical connection
This machine is designed to operate on a 220-240 V,
single-phase, 50 Hz supply.
Check your domestic electrical installation can take
the maximum load required (2.2kW), also take into
account any other appliances in use.
Connect the machine to an earthed socket, in
accordance with current wiring regulations.
CAUTION: If the appliance is supplied with a cord
extension set of an electrical portable outlet device,
it must be positioned so it is not subjected to
splashing or ingress of moisture.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution.
Should the appliance power supply
cable need to be replaced, this must
be carried out by our Service Centre.
Important!
The power supply cable must be accessible after
installing the machine.
Stacking kit
Stacking kits are available through your dealer. This
enables the mounting of the dryer on top of your
front loading Zanussi washing machine, with
cover's depth between 40 and 60 cm.
Door reversal
To make it easier to load or unload the laundry the
door can be reversed.
This operation must be carried out by qualified
personnel.
Please contact the nearest Service Centre.
7
Advertisement
Table of Contents
