Table of Contents
Advertisement
Maintenance and Cleaning
You must disconnect the dryer from the electricity
supply before carrying out any cleaning or
maintenance work.
External cleaning
Use soap and water only, dry thoroughly.
Important: do not use methylated spirit, diluents or
similar products.
Cleaning the door
Clean periodically the interior part of the door to
remove any fluff from the seals around the filter.
Accurate cleaning ensures correct drying.
Cleaning the filters
Your dryer will only function well if the filters are
clean.
The filter collects lint accumulated during drying.
The filter must be cleaned at the end of each
program.
The CLOGGED CONDENSER light is on to remind
you of this operation.
The filter in the inner door must be removed for
cleaning.
Do not be alarmed by the amount of lint, it is not
due to excessive wear caused by the dryer.
All fabric loses lint when drying but it goes
unnoticed in the air.
In a tumble dryer it collects in the filter.
After a while a whitish pattern due to detergent
residue forms on the filters. When this occurs, clean
the filter with warm water using a brush.
Remove the filter in the door opening as per picture
(it can be positioned with the tooth facing to the left
or to the right.).
Do not use the appliance without filters.
Cleaning the condenser unit
Clean the condenser when the CLOGGED
CONDENSER light comes on.
The condenser is situated at the lower part of the
cabinet behind a small door. To open the door,
push the catch as per picture.
During the drying cycle or at the end, it is normal for
water to be present on the surface of the condenser
insertion.
To pull out the condenser, first turn the two red
stops downwards and then remove the condenser
unit holding the handle.
13
Advertisement
Table of Contents
