Advertisement
Installation
Positioning
It is recommended that, for your
convenience, the tumble dryer is positioned
close to your washing machine. A wall
bracket is available to enable you, if
required, to attach the dryer to a wall. This
can be obtained from the Zanussi Service
Network.
Whilst drying, the tumble dryer will expel
a certain amount of warm, very moist air,
and this should be removed from the room
as quickly as possible to prevent
condensation. In an extremely well
ventilated room or close to an open
window, this may occur naturally.
However, in general, it is better to carry
the dryer's exhaust outside via a length of
100mm diameter flexible trunking
(available as an optional extra from your
Zanussi agent); ending either temporarily
at an open window, or permanently at a
flxed ventilation grille, fitted to an exterior
wall or window (Fig. 1).
Fitting the Trunking
To simplify the installation, there is a choice
of vent outlets: one at the back; the other in
the left hand side (Fig. 2). Connect the
trunking to whichever is the more
convenient by pulling the ring nut from the
vent, screwing it on to the trunking, and
The unused vent should now be sealed with
the special cover provided. If you find that,
when delivered, the dryer has the cover
and ring nut fitted to the wrong vents,
merely switch them round before
connecting the trunking - the cover is fixed
with two screws.
Once connected to the dryer, run the
trunking to the desired outlet point,
ensuring that the run's overall length is less
than 2m, and that it contains no more than
two bends. As to the outlet itself, if you
have decided on a fixed wall/window grille,
a venting kit is available from your local
Zanussi Service Network.
Advertisement
