Table of Contents
Advertisement
Installation
Positioning
Whilst drying, the tumble diyer will
expel a certain amount of warm, very
moist air, and this should be removed
from the room as quickly as possible to
prevent condensation. In an extremely
well ventilated room or close to an open
window, this may occur naturally.
However, in general, it is better to carry
the diyei^s exhaust outside via a length
of 100mm diameter flexible trunking
(available as an optional extra from your
Zanussi agent); ending either temporarily
at an open window, or permanently at a
fixed ventilation grille, fitted to an
exterior wall or window (Fig. 1).
Fitting the TrunMng
To simplify the installation, there is a
choice of vent outlets: one at the back;
the other in the left hand side (Fig. 2).
Connect the trunking to whichever is the
rnore convenient by pulling the ring nut
from the vent, screwing it on to the
trunking, and pushing it firmly back into
place (Fig. 3).
The unused vent should now be sealed
with the special snap cover provided. If
you find that, when delivered, the dryer
has the cover and ring nut fitted to the
wrong vents, merely switch them round
before connecting the trunking - the
snap in cover just levers out.
Once connected to the dryer, run the
trunking to the desired, outlet point,
ensuring that the run's overall lenght is
less than 2m, and that it contains no
more than two bends. As to the outlet
1
1
i
i
1
1
j
i
1
1
4
2
0
^
Advertisement
Table of Contents
