ENGLISH Important Safety Information These warnings are provided in the interest of safety. You read them carefully before MUST installing or using the appliance. Installation Service This hob must be installed by qualified personnel, This hob should only be repaired or serviced by an according to the manufacturer’s instructions.
Contents For the User For the Installer Important Safety Information Technical Data Description of the Hob Instruction for the Installer Instruction for the User Building In Maintenance and Cleaning Possibilities for insertion Something Not Working? Electrical connections Commissioning MANUFACTURER: ELECTROLUX HOME PRODUCTS ITALY S.p.A. Viale Bologna, 298 47100 FORLÌ...
Instruction for the User Hob burners control knobs The symbols on the hob burners control knobs mean that: there is no gas supply there is maximum gas supply there is minimum gas supply Lighting the burners For easier lighting, proceed before putting a pan on the pan support.
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool.
Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SYMPTOM SOLUTION Check that the unit is plugged in and the electrical There is no spark when lighting the gas supply is switched on Check the mains fuse has not blown Check the burner cap and crown have been replaced...
Technical Data Overall dimensions Gas Burners Rating Rapid Burner 2.45 kW Width 750 mm Auxiliary Burner 0.95 kW Depth 510 mm Semi-rapid Burner 1.60 kW Hob recess dimensions Length 560 mm Appliance Class Width 480 mm Appliance Category Appliance Gas Supply LPG 30 mbar Gas connection RC 1/2 inch (1/2 inch male)
Building In Fig. 5 Dimensions are given in millimeters These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hob dimensions are shown in Fig. 5. The edge of the cut out must have a minimum distance from the rear wall of 55 mm.
Possibilities for insertion Kitchen unit with door Kitchen unit with oven Proper arrangements must be taken in designing the The hob recess dimensions must comply the indication forniture unit, in order to avoid any contact with the given in Figs. 10 and 11 and must be provided with bottom of the hob which can be heated when it is brackets to allow a continuous supply of air.
Electrical connections Permanent Connection Any electrical work required to install this hob should be carried out by a qualified electrician or In the case of a permanent connection, it is necessary competent person, in accordance with the current that you install a double pole switch between the hob regulations.