Service Reminder; Diagnostics - Hellenbrand promate 6.0 Owner's Manual

SERVICE ALARM
BOTH
SET
SCHEDULED SERVICE
0.25
YR
SET
SCHEDULED SERVICE
80000
GAL
SET
RETURN TO NORMAL MODE
Reset Diagnostic Values: Hold
DAYS SINCE REGEN
2
DAY
SINCE LAST REGEN
342
GAL
RESERVE HISTORY
0 160
DAY GAL
13

serviCe reMinDer

STEP 27S – Set scheduled service display using  or  buttons. Available options are OFF, TIME,
Step 27S
ON GAL or BOTH. Selecting OFF disables this feature. If OFF is selected, press NEXT to exit
System Setup. If TIME, ON GAL or BOTH is selected press NEXT to select the TIME and/or ON
GAL values. See Steps 28S and/or 29S. When days fall below 1 year, display shows "SCHED-
ULED SERVICE in XXX DAYS", so service technician can reprogram if desired. This can also acti-
vate relay if Service Alarm is selected on Step 22S. Press REGEN to return to the previous step.
STEP 28S – Service alarm for TIME ranges from 0.25 to 9.75 years. Press  and  buttons to-
Step 28S
gether until "set" appears to select value. Press NEXT to either exit System Setup or if BOTH was
selected go to Step 29S. Press REGEN to return to the previous step. When time selected and
# of days drops below 1 year, the display in OEM program will show "scheduled service in XXX
days" right after screen where service reminder is programmed.
Step 29S
STEP 29S – Service alarm for ON GAL ranges from 100 to 9,999,900 gallons. Press  and 
buttons together until "set" appears, use arrows to select value. Press NEXT to exit System Setup.
Press REGEN to return to the previous step.
Reset service reminder by pressing up and down arrows together when reminder is displayed.
=  Up Arrow
NEXT/DOWN buttons for 3 seconds, then hold
STEP 1D – Press  or  simultaneously for three seconds. If screen in step 2D does not
STEP 1D
appear in 5 seconds the lock on the valve is activated.
STEP 2D – Days, since last regeneration: This display shows the days since the last regenera-
STEP 2D
tion occurred. Press the NEXT button to go to Step 3D. Press REGEN to exit Diagnostics.
STEP 3D – Volume, since last regeneration: This display shows gallons of water that has been
STEP 3D
treated since the last regeneration. This display will equal zero if a water meter is not installed.
Press the NEXT button to go to Step 4D. Press REGEN to return to previous step.
STEP 4D – Volume of reserve capacity used for last 7 days: If the unit is set up as a softener,
STEP 4D
a meter is installed and Set Volume Capacity is set to "Auto", this display shows 0 day (for today)
and the reserve capacity. Pressing the  button will show day 1 (which would be yesterday) and
displays the reserve capacity. Pressing the  button again will show day 2 (the day before yester-
day) and the reserve capacity. Keep pressing the  button to show the capacity for days 3, 4, 5
and 6. The  button can be pressed to move backwards in the day series. Press NEXT button at
any time to go to Step 5D. Press REGEN to return to previous step.

DiaGnOsTiCs

=  Down Arrow
UP/DOWN buttons for 3 seconds.