Oce im2330 Printing Manual page 289

— Finishing
In the Finishing menu, you can set destination, hole punching and stapling.
1
2
3
1) Destination
This selects the destination tray.
- Inner Tray — Select this when no finisher is installed.
- Tray 1 — Select this to route the output to the upper tray of the Finisher.
- Tray 2 — Select this to route the output to the lower tray of the Finisher.
- Job Separator Upper — Select this to route the output to the upper tray of the Job Sep-
arator.
- Job Separator Lower — Select this to route the output to the lower tray of the Job Sep-
arator.
For im4530 Sereis, "Tray 1" and "Tray 2" can be selected when the Hanging Finisher,
Finisher (Type A), Finisher (Type B), or Saddle Stitch Finisher are installed.
When the Finisher (Type B) is installed in the im4530 Series and stapling is enabled,
select "Tray 2".
For im2830 Sereis, "Tray 1" and "Tray 2" can be selected when the Hanging Finisher is
installed, and "Tray 1" can be selected when the Saddle Stitch Finisher is installed.
When the optional Job Separator is installed, you can select "Job Separator Upper" and
"Job Separator Lower" instead of "Inner Tray".
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off — Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
Printing from Application on Mac OS X 10.2.4 to Mac OS X 10.4.x 287