Mains Power Connection; Switching On And Off; Changing Replay Speed; Maintenance And Cleaning - Pro-Ject Audio Systems Pro-Ject RPM 10 Instructions For Use Manual

Mains power connection

The turntable is supplied with a power supply suitable for your country's mains supply. Check the label before
connecting to ensure compliance with the mains rating in your house.
Connect the low voltage plug from the power supply to the record player's motor unit (13) before connecting
the power supply to the mains.

Switching on and off

Pressing the power switch (20) alternately starts or stops the motor.

Changing replay speed

Using the accessory tool provided (3a), hook the belt (3) over the larger diameter part of the motor pulley (2).
To revert to 33 1/3 r.p.m. repeat the proceedings using the smaller step on the pulley.
When the Pro-Ject Speed Box ore the Speed Box SE are used speed change between 33 and 45 r.p.m.
is electronic. There is no need to move the belt manually.
For detailed product information please refer to the Pro-Ject web site

Maintenance and cleaning

Your record player requires little or no regular maintenance. Remove dust with a slightly moistened antistatic
cloth. Never use a dry cloth because this will create static electricity which attract more dust! Antistatic
cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber
parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage.
If the player is not used over a long period of time the drive belt can be removed to prevent unequal stretching.
Always disconnect the record player from the mains power supply as a precaution before maintenance!

Useful tips

The base and the record player should be positioned on a low-resonance surface such as wood or multiple
layer ply board to avoid structural vibrations disturbing replay.

Technical specifications PRO-JECT RPM 10

Nominal speeds
Speed variance
Wow and flutter
Signal to noise
Downforce range
Effective tonearm length
Overhang
Power consumption
Outboard power supply
Dimensions (W x H x D)
Weight
Dimensions base (W x H x D)
Weight base
6
© Audio Trade GmbH · Pro-Ject RPM 10 · Revision 1.3.08/1.5.08
33,33/45,11 r.p.m.
±0,5 %
±0,01 %
-73dB
10-35mN
10 " (254mm)
16mm
2W
16V/500mA AC, suitable for your country's mains supply
480 x 210 x 330mm
16,5kg
500 x 65 x 400mm including spikes. H without spikes 44mm
11,6kg
www.project-audio.com