HP MCS-200 User Manual page 55

Question
Why do I get an extra line feed sent
from Microsoft® Windows® when I
access the serial interface using an
HP serial console switch?
Is water prevented from entering the
MCS-200 unit if a pipe breaks?
What will happen if water stops
flowing to the MCS-200 unit?
Can I install an MCS-200 unit to an
existing rack in my data center?
Can I cool two racks with one
MCS-200 unit?
Can I install an existing rack in my
data center to my MCS-200 unit as
my secondary rack?
Will my secondary rack have the
ability to use the Automatic Door
Release Kit?
Answer
Enter these commands while logged in as Admin on the HP serial
console switch console port (where port x is the port connected to the
MCS management module):
port x set out lf=strip
port x set flow=Xonxof
Yes, the MCS-200 unit is physically separate from the server
enclosure. Therefore, there is no situation in which water can come
directly in contact with the servers. The base unit of each cooling
module acts as a condensation tray for water. These trays are
connected together, so that any water drains away at once through the
condensation drain. Also, each heat exchanger module has a leak
and condensation tray that transfers water to the bottom of the
MCS-200 unit where it flows to the building condensation return
system. If a leak occurs, the integrated leak sensor detects it and an
alarm would is issued so that action can be quickly taken.
If you have the Automatic Door Release Kit installed and enabled, an
alarm will trigger the doors of the rack to open, allowing the servers to
be cooled by the room ambient temperature.
No, the MCS-200 unit ships with an empty HP rack. However,
Configure to Order (CTO) is available.
Yes, the HP Expansion Rack Kit is available to install to your MCS-200
unit. You can cool a rack on either side of the MCS-200 unit.
No, you must order the HP Expansion Rack Kit to ensure the proper fit
and functionality of the secondary rack.
Yes, you can install the HP Automatic Door Release Kit on your
Expansion Rack. If the Automatic Door Release function is enabled, it
automatically controls the automatic door release functionality of both
racks.
Frequently asked questions 55