Connecting The Monitor To A Power Source; Turning The Power On - Princeton SENergy 714 Reference Manual

Connecting the monitor and turning the monitor on and off
Connecting the monitor to a power
source

Turning the power on

1. Press the monitor's POWER button.
The power LED will light up orange.
2. Turn on the computer.
When a signal is input from the computer, the
power LED lights up green, and the screen is
displayed. (After power is turned on, it may take a
little time until the screen is displayed.)
Notes：
- If the input terminal to which the computer is
connected has not been selected, the screen will not
be displayed. If necessary, perform input terminal
switching. (P7.)
- When using an analog signal, perform an automatic
screen adjustment under the following conditions
(P10.)
- Using the monitor for the first time.
- After having changed the system settings during
use.
- When connecting to a notebook, if the notebook
computer's screen is set so that it is displaying at
the same time, the MS-DOS screen may not be able
to display properly. In this case, change the settings
so that only the monitor is displaying.
6