Table of Contents
Advertisement
Connecting the monitor and turning the monitor on and off
CAUTION!
- When connecting, ensure that both the monitor
and computer are switched off.
- Be careful not to overly bend the cable or add
extension cords as this could lead to a malfunction
Connecting the monitor to a computer
Connecting using accessory analog signal cable
Connect the analog signal cable to the analog RGB
output terminal of the computer.
- For analog connection, use the analog signal cable
accessory or a commercially available one (both
ends should be mini D-sub 15 pin).
- Paying attention to connector direction, firmly
insert the signal cable vertically into the connector,
and then tighten the screws at both sides.
If connecting to a D-sub 15 pin 2 rows Apple
Power Macintosh, attach a Macintosh conversion
adapter (commercially available) to the analog
signal cable.
Note:
- If connecting to the Sun Ultra series, a conversion
adapter (commercially available) may be required.
When connecting using separately sold digital or
analog or analog signal cables
The separately sold display cable enables
connection between the DVI-I input terminal on the
monitor and the digital or analog RGB output
terminal of the computer.
When connecting to a digital RGB output
terminal:
- Use a digital signal cable.
- For digital RGB connection, the monitor has an
input for connecting to a computer with a DVI
compatible output connector (DVI-D24 pin or
DVI-I29 pin) and SXGA output capability.
(Depending on the type of computer to be
connected, the display may not work correctly.)
When connecting to an analog RGB output
terminal:
- Use an analog signal cable.
- Paying attention to connector direction, firmly
insert the signal cable vertically into the connector,
and then tighten the screws at both sides
Connect the accessory audio cable
When the accessory audio cable is connected to the
audio output terminal of the computer, the sound of
the connected computer is output from the monitor
speakers.
5
Advertisement
Table of Contents
