Building-In; Levelling; The Furniture Door - Zanussi ZDS 679 EX Instruction Booklet

Building-in

It is essential that the recess dimensions indicated
in the diagram are followed.
No further openings for venting of the dishwasher
are required, but only to let the water fill and drain
hose and power supply cable pass through.
The recess height may be anywhere between 820
and 880 mm from the floor since the dishwasher
incorporates adjustable feet (max 60 mm).
A distance of 2 mm should be allowed between the
top of the dishwasher and the counter top.
When inserting the machine, ensure that the water
inlet and drain hoses are not kinked or squashed.

Levelling

Good levelling is essential for correct closure and
sealing of the door. When the appliance is correctly
levelled, the door will not catch on the levelling
spacers, either side of the cabinet.
If the door does not close correctly, loosen or
tighten the adjustable feet until the machine is
perfectly level.

The furniture door

The door of this appliance is designed for the
overlay of a panel having the following dimensions:
Width 596 mm max
Height * 50 - 120 mm max
Thickness 20 mm max
* The height of the panel depends on the height of
the kitchen plinth.
Attention
The panel height should be no more than
indicated, otherwise complete opening of the door
will no longer be possible as the panel hits against
the dishwasher plinth.
Mounting the furniture door
1. Drill the panel with a Ø 2 x 12 bit according to
the dimensions indicated in the figure.
2. Fix the panel to the cross bar provided with 2
screws 3,5 x 16.
3. Fix the cross bar to the dishwasher door with 2
screws 3,5 x 16 after having inserted the two
hooks of the cross bar on the lower section of
the door.
II72
II71
458 458
II69
50
II70
PFI19GB