Adjusting The Door Balance; Fixing To The Adjacent Units - Zanussi ZDS 679 EX Instruction Booklet

Adjusting the door balance

When the dishwasher door is correctly balanced it
will remain in position when left ajar.
Fitting the decor panel may sometimes affect this
balance. In this case it will be necessary to adjust
the balance as follows:
Half-open the door and regulate the screws located
on the kick plate.
By screwing or unscrewing these screws, the
tension of the door balancing springs is increased
or decreased respectively.
The weight of the panel should be within the limits
given in the "dimensions of the panel", otherwise
balancing the door will not be possible.

Fixing to the adjacent units

To prevent the dishwasher tilting, it must be
secured to either the worktop or adjacent kitchen
cabinet/wall using the brackets supplied. Insert the
two fixing brackets into the slots provided in the top
front part of the dishwasher as shown in the figure.
Secure the brackets to adjacent units with the 3.5 x 16
screws using the upper or the side holes.
The appliance must be secured to the
underside of the worktop using the brackets
provided.
Failure to do this could cause damage or
injury.
II08
II54
51
PFI18GB