Unpacking The Machine; If The Machine Is Damaged; Protecting The Machine Against Freezing; Building-In - Zanussi DCS 383 Instruction Booklet

Unpacking the machine

If the machine is damaged

If the machine has been damaged during transportation,
you should immediately notify the company responsible
for delivering it.
Check that the dishwasher is undamaged. If you discover
any damage, faults or that anything is missing, you should
notify the seller immediately.
Never leave packaging material in a place
where children may play with it.
Check that the following accessories are supplied with
the dishwasher when you unpack it:
Elbow for discharge hose (1)
A funnel for filling with salt (2)
Protecting the machine against
freezing
If the machine is kept in a place where the temperature
may sometimes fall below 0°C, there is a risk that the
small amount of water which remains inside parts of the
machine after normal use will freeze and damage it.
To prevent this you should:
1. Turn off the water supply to the machine and
disconnect the water intake hose from the
supply pipe.
2. Select a wash programme, start the machine
and let the programme run for a short time.

Building-in

If you want to build the dishwasher into your kitchen
furniture, it is important to use our approved build-in kit.
This comes with the correct instructions needed to
observe all the relevant regulations.
You can obtain the build-in kit from the same place
where you bought the dishwasher.
Identification of materials
All materials used in packaging this machine are
environmentally-friendly. The various plastics used
are identified and can be recycled:
• PE stands for polyethylene, which is used for the bag
around the machine and the bag in which these
instructions were supplied.
• PS stands for polystyrene (moulded), which is used for
the sections of packaging needed to cushion the machine.
The cardboard components of the packaging are made
from recyclable paper and should be taken to a collection
point for recycling.
The machine contains plastic and rubber components.
These have identifying marks to show what they are
made from, so they can be recycled or disposed of
properly at the end of the machine's life. The materials
are identified according to international standards.
- 10 -
1
2