Things To Note; To Fit The Top Oven Shelf; Hints And Tips - Zanussi ZDQ 695 Instruction Booklet

THINGS TO NOTE

·
The indicator neon will glow. It may turn ON and
OFF during use to show that the setting is being
maintained.
·
The cooling fan for the controls may operate after
a time.
Do not place dishes, tins and trays directly
on the oven base as it becomes very hot
and damage will occur.

TO FIT THE TOP OVEN SHELF

The cranked shelf should be fitted with the straight
rods uppermost on the frame and the forms towards
the back of the oven.
To remove a shelf slide the shelf towards you until
the shelf stop is reached. Tilt shelf up at the front so
that the stops clear the side supports. Lift shelf clear.
To install a shelf, reverse the above steps.
shelf position has an upper and lower support wire,
ensure the shelf is placed between these two support
wires.

HINTS AND TIPS

·
Single level cooking gives best results. If you
require more than one level of cooking use the
main fan oven.
·
The middle shelf allows for the best heat
distribution. To increase base browning simply
lower the shelf position. To increase top
browning raise, the shelf position.
·
There should always be at least 2.5cm (1")
between the top of the food and the element.
This gives best cooking results and allows room
for rise in yeast mixtures, Yorkshire puddings etc.
When cooking cakes, pastry, scones, bread etc.,
place the tins or baking trays centrally below the
element.
·
Ensure that food is placed centrally on the shelf
and there is sufficient room around the baking
tray or dish to allow for maximum circulation.
·
Stand dishes on a suitably sized baking tray on
the shelf to prevent spillage onto the oven base
and to help reduce cleaning.
Each
14