Casio CTK-7300IN User Manual page 102

5.
Use buttons R-1 (5) to R-4 ( • ) and buttons R-7 (6) to R-10 (,) to specify the length of the note you want
to input.
• For information about how to specify note lengths, see step 4 under "To insert an event" (page E-94).
• You can perform the following operations during step input to insert ties and rests.
To do this:
Tie the note at the
current cursor position
with the note event
immediately before it
Insert a rest before the
current cursor position
6.
Press the keyboard key that corresponds to the note you want to input.
• The note is input as soon as you press the keyboard key, and the cursor will move by the length you specified in step 5 to the
next measure:beat:tick. From there you can input the next note, if you want.
7.
Repeat steps 5 and 6 to input the notes you want.
• If you want to input a series of notes of the same length, skip step 5 and perform step 6 only.
8.
After inputting all of the notes you want, press the R-15 (EXIT) or R-17 (t, y) button.
• This returns to the event editor screen.
Input Menu Setting Items
Pressing the C-17 (MENU) button while holding down the R-13 (FUNCTION) button during step input will display the input menu.
The following explains the meanings and setting ranges of the input menu items. The settings marked with an asterisk (*) in the
"Setting Range" column are initial defaults.
Item name
GateRate Specifies the gate rate as a percentage of the actually input gate length for the
(Gate Rate) length (gate length) of the note event that was specified using buttons R-1 (5)
through R-4 ( • ) and R-7 (6) through R-10 (,). Specifying a GateRate of
080% and inputting a quarter note (96 ticks), for example, will result in a GATE
setting of 00:76 (96
Velocity Specifies the velocity value of an input note event or chord event. Specifying
(Velocity) "KeyOn" inputs a velocity value in accordance with applied key pressure.
SysTrack Selects either note event input or chord event input when inputting to the
(System Track) system track.
1. At the current cursor position, specify the length of the note you want to tie with the immediately
preceding note event.
2. Press the R-11 (.) button.
• This adds the length of the note you specified in step 1 to the length of the note immediately
preceding it. At this time, the cursor will move forward by the timing of the added amount.
6 2 6
A B A
1. At the current cursor position, specify a note that is the same length as the rest you want to insert.
2. Press the R-5 (REST) button.
• The cursor will move forward by the length of the note you specified in step 1.
6 2 6
B
0.8 = 76.8, cut off to 76).
X
Perform this operation:
2 2
A Preceding note event
B
Current cursor position
C
C Cursor position after process
2
B Current cursor position
C
C Cursor position after process
Description
Using the Song Sequencer
Setting Range
*
001% to 080% to 100%
KeyOn, 001 to 100
*
note , Chord
*
to 127
E-101