Table of Contents
Advertisement
EJU32660
Engine shut-off cord
Check that the engine shut-off cord is not
frayed or broken. If the cord is damaged, re-
place it; never try to repair it or tie it together.
EJU32670
Switches
ECJ00410
CAUTION:
Do not run the engine for more than 15
seconds when checking the switches on
land without supplying water, otherwise
the engine could overheat.
Check the start switch, the engine stop
switch, and the engine shut-off switch for
proper operation.
Push the start switch to start the engine. As
soon as the engine starts running, push the
engine stop switch to verify that the engine
stops immediately. Restart the engine, and
then pull the engine shut-off cord to remove
the clip from the engine shut-off switch to ver-
ify that the engine stops immediately. (See
pages 24 to 24 for information on proper op-
eration of the start switch, the engine stop
switch, and the engine shut-off switch.)
1 Engine shut-off switch
2 Start switch
3 Engine shut-off cord
4 Engine stop switch
5 Clip
EJU32680
Cooling water pilot outlet
Check that water comes out from the cooling
water pilot outlet while the engine is running
and the watercraft is in the water. (See page
25 for more information.)
Operation
36
Advertisement
Table of Contents
