Yamaha RX10H Owner's Manual page 87

2. Open the shroud.
3. Remove the red (+) lead from the lead
holder and move it away from the black
(-) lead.
CAUTION :
@
Be sure to connect the red (+) jumper
cable to the red (+) lead and the black (-)
jumper cable to the black (-) lead. Do not
reverse the connections.
@
4. Pull the red (+) lead cover to expose
the terminal through the slit in the
cover, and then connect the red (+)
jumper cable to the red terminal of the
discharged battery.
5. Connect the other end of the red (+)
jumper cable to the positive (+) terminal
of the booster battery.
6. Connect the black (-) jumper cable to
the negative (-) terminal of the booster
battery.
7. Pull the black (-) lead cover to expose
the terminal through the slit in the
cover, and then connect the black (-)
jumper cable to the black terminal of
the discharged battery.
8. Start the engine.
9. Disconnect the black (-) jumper cable
from the black (-) connecting lead, and
then pull the cover completely over the
lead terminal.
10. Disconnect the black (-) jumper cable
from the negative (-) terminal of the
booster battery.
11. Disconnect the red (+) jumper cable
from the positive (+) terminal of the
booster battery.
12. Disconnect the red (+) jumper cable
from the red (+) connecting lead, and
then pull the cover completely over the
lead terminal.
13. Install the red (+) lead into the lead
holder.
9-2