Table of Contents
Advertisement
ESU00039
Headlight beam switch
Push the headlight beam switch to change the headlight
beam to high or low.
1 Headlight beam switch
2 Push
3 High beam
4 Low beam
ESU00048
Shroud latches
To open the shroud, unhook the shroud latches, and then
slowly raise the shroud forward until it stops. When clos-
ing the shroud, slowly lower it to its home position, and
then hook the shroud latches.
1 Shroud latch
2 Shroud
CAUTION :
@
Make sure that all cables and wires are in place when
closing the shroud.
@
WARNING
@
G
Do not drive the snowmobile with the shroud
open, unlatched, or removed.
G
Keep your body and clothing away from rotating
parts when servicing with the shroud open.
G
Do not touch the hot muffler and engine during or
immediately after operation.
@
ESU00052
Drive guard
The drive guard is designed to cover the V-belt clutch
and V-belt in case parts break or come loose.
WARNING
G
Make sure that the drive guard is tightened
securely before operating the snowmobile.
G
Never run the engine with the V-belt or drive
guard removed.
@
5-12
Advertisement
Table of Contents
