Table of Contents
Advertisement
ESU00197
Rear suspension full rate adjustment
The total suspension spring rate and damping character-
istics can be adjusted by changing the installed position
of the shock absorber.
WARNING
@
Be sure to have a Yamaha dealer make this adjust-
ment.
@
CD-07E
Installation position
Spring rate and
damping
Standard
NOTE:
@
Be sure to make this adjustment when there is no load
(rider or cargo) on the snowmobile.
@
1. Loosen the full rate adjusting nut 1 1/2 or 3/4 turn,
while holding the adjusting bolt 2 securely with a
wrench so it does not move.
CAUTION :
@
Never allow the adjusting bolt 2 to move while loos-
ening the nut.
@
2. Turn the adjusting bolt 2 to the desired position.
CAUTION :
@
Make sure that the adjusting bolt ends are set at the
same position on each side.
@
3. While holding the adjusting bolt securely, tighten the
full rate adjusting nut 1.
Full rate adjusting nut tightening torque:
49 Nm (4.9 m·kgf, 35.4 ft·lb)
CAUTION :
@
Never allow the adjusting bolt to move while tighten-
ing the nut.
@
8-24
C
B
Hard
Medium
B
A
Soft
Advertisement
Table of Contents
