Adjusting The Headlight Beams; Fittings And Fasteners; Battery; Replacing A Fuse - Yamaha PZ50RTX Owner's Manual

ESU12280

Adjusting the headlight beams

Turn the headlight beam adjusting screws in
or out to adjust the headlight beams. The
headlight beams move as follows depending
on the turning direction of the headlight beam
adjusting screws.
Direction (a): Down and to the left
G
Direction (b): Up and to the right
G
Direction (c): Down and to the right
G
Direction (d): Up and to the left
G
1. Headlight beam adjusting screw
ESU12290

Fittings and fasteners

Check the tightness of the fittings and fasten-
ers.
Tighten in proper sequence and torque if nec-
essary.
ESU12300

Battery

This snowmobile is equipped with a sealed-
type (MF) battery, which does not require any
maintenance. There is no need to check the
electrolyte or to add distilled water.
To charge the battery
Have a Yamaha dealer charge the battery as
soon as possible if it seems to have dis-
charged. Keep in mind that the battery tends
to discharge more quickly if the snowmobile is
equipped with electrical accessories.
Periodic maintenance
EWS00540
WARNING
Battery electrolyte is poisonous and dan-
gerous. It contains sulfuric acid and can
cause severe burns. Avoid contact with
skin, eyes, or clothing.
ANTIDOTE:
EXTERNAL: Flush with water.
G
INTERNAL: Drink large quantities of wa-
G
ter or milk. Follow with milk of magne-
sia, beaten egg, or vegetable oil. Call
physician immediately.
EYES: Flush with water for 15 minutes
G
and get prompt medical attention.
Batteries produce explosive gases. Keep
sparks, flame, cigarettes, etc. away. Venti-
late when charging or using in an en-
closed space. Always shield your eyes
when working near batteries.
KEEP OUT OF THE REACH OF CHILDREN.
ESU12351

Replacing a fuse

EWS00550
WARNING
Be sure to use the specified fuse. A wrong
fuse could cause electrical system dam-
age or A FIRE HAZARD.
ECS00631
CAUTION:
Be sure to turn the main switch to the off
position and disconnect the negative bat-
tery lead to prevent accidental short-cir-
cuiting.
1. Remove the right side cover. (See page
45 for removal procedures.)
2. Disconnect the negative battery lead.
3. Replace the blown fuse with one of the
proper amperage.
69