2.
Remove the coolant reservoir cap, add
the recommended coolant until it reaches
the "COLD LEVEL" mark, and then install
the cap.
1. "COLD LEVEL" mark
2. Coolant reservoir cap
Recommended antifreeze:
High-quality ethylene glycol antifreeze
containing corrosion inhibitors
Antifreeze and water mixing ratio:
3:2
Total amount:
PZ50GT 3.60 L (3.81 US qt) (3.17
Imp.qt)
PZ50MT 3.60 L (3.81 US qt) (3.17
Imp.qt)
PZ50RT 3.60 L (3.81 US qt) (3.17
Imp.qt)
PZ50VT 3.70 L (3.91 US qt) (3.26
Imp.qt)
3.
Start the engine, allow it to idle for several
minutes, and then turn it off.
4.
Check for any coolant leakage.
Periodic maintenance
NOTE:
If you find any leaks, consult a Yamaha deal-
er.
5.
Install the right upper cover, and then in-
stall the top cover (PZ50RT / PZ50GT /
PZ50MT) or close the shroud (PZ50VT).
ESU12080
V-belt
EWS00400
WARNING
Make sure that the drive guard is tight-
G
ened securely before operating the
snowmobile.
Never run the engine with the V-belt or
G
drive guard removed.
The V-belt should be checked before each
ride.
To check the V-belt
1.
Remove the left side cover (PZ50RT /
PZ50GT / PZ50MT), or open the shroud
and remove the left upper cover and the
left side cover (PZ50VT). (See page 45
for removal procedure.)
2.
Remove the drive guard.
3.
Check the V-belt for wear and damage.
Replace if necessary.
1. V-belt wear limit
New V-belt width:
34.1 mm (1.34 in)
V-belt wear limit width:
32.5 mm (1.28 in)
57