Control functions
1. "SELECT" button
2. "RESET" button
NOTE:
To switch the speedometer, odometer, and
G
tripmeter displays between kilometers and
miles, select the odometer mode "ODO",
and then push the "SELECT" button for at
least 10 seconds while the snowmobile is
stopped.
Use the engine speed meter only when
G
checking the snowmobile and performing
basic maintenance. The engine speed
meter should not be used while riding the
snowmobile since the reading will vary from
the actual engine speed.
ESU10410
High beam indicator light "
The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 17 for headlight beam switch
operation.)
1. High beam indicator light "
12
ESU10471
Low coolant temperature indi-
The low coolant temperature indicator light
comes on when the coolant temperature is
low and informs the rider that the snowmobile
should be warmed up. After the engine is
started, warm it up until the indicator light
goes off.
1. Low coolant temperature indicator light
The snowmobile can be operated normally af-
ter the indicator light goes off.
NOTE:
Operate the snowmobile at low speeds when
the low coolant temperature indicator light is
on. If the engine speed is too high, maximum
"
engine speed is reduced to protect the en-
gine.
ESU10500
Knock control system "KCS"
This snowmobile is equipped with a system
which detects engine knocking in order to pro-
tect the engine from damage.
The knock control system "KCS" indicator
light comes on if knocking is detected, then
flashes if the knocking increases.
"
cator light "
"
"
indicator light
"