High Beam Indicator Light - Yamaha Vector RS90LTGTZ Owner's Manual

been reached), the tripmeter must be reset af-
ter the oil change for the next periodic oil
change to be indicated at the correct time.
In that case, reset the oil change tripmeter as
follows.
1. Push the "SELECT" button until "ODO" is
displayed, then push the "RESET" button
for approximately 1 second. The distance
traveled since the last oil change and
"OIL" will flash alternately in the odometer
display.
2. Push the "RESET" button for approxi-
mately 3 seconds. "00000" and "OIL" will
flash alternately in the odometer display 3
times, and then the display will return to
the previous display mode.
Clock
F
E
1. Clock
To set the clock
1. Turn the main switch to the on position.
2. Push the "SELECT" button and "RESET"
button simultaneously until the hour digits
start flashing.
3. Push the "RESET" button to change the
hour setting, and then push the "SE-
LECT" button. The minute digits will start
flashing.
4. Push the "RESET" button to change the
minute setting, and then push the "SE-
LECT" button. The clock starts when the
"SELECT" button is released.
1
Control functions
TIP
The clock must be set again when the battery
is disconnected.
Display brightness control
This function allows you to adjust the bright-
ness of the meter unit display to suit the out-
door lighting conditions.
1. Display brightness level
To adjust the display brightness
1. Turn the main switch to the off position.
2. Push and hold down the "SELECT" but-
ton.
3. Turn the main switch to the on position,
and then, after 5 seconds, release the
"SELECT" button.
4. Push the "RESET" button to select the
desired display brightness level, and then
push the "SELECT" button. The display
returns to the previous display mode.
ESU10410

High beam indicator light "

The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 17 for headlight beam switch
operation.)
1
"
13