Yamaha CDR401t Series User Manual page 12

Chapter 2 - Installing the Yamaha CDR401t Drive
Setting the CDR401t as the MASTER
As shown in the diagram at the right, insert the
jumper pin into the right edge of the jumper
switch.
Note: If only the CDR401t will be connected to the
IDE interface connector, connect the CDR401t
to the end of the connector.
Setting the CDR401t as the SLAVE
As shown in the diagram at the right, insert
the jumper pin into the middle of the jumper
switch.
CSEL (Cable SELect)
If you use the CSEL setting, the MASTER/SLAVE setting will be
made automatically depending on the hardware configuration.
For details refer to the manual of your computer.
6
CSEL
T
SLAVE
MASTER
IDE INT
CSEL
T
SLAVE
MASTER
IDE INT