EMU29471
Replacing fuse
If a fuse has blown, remove the electrical
cover, open the fuse holder and remove the
fuse with a fuse puller (if equipped). Replace
it with a spare one of the proper amperage.
EWM00630
WARNING
Be sure to use the specified fuse. An in-
correct fuse or a piece of wire could allow
excessive current flow. This could cause
electric system damage and a fire hazard.
NOTE:
Consult your Yamaha dealer if the new fuse
immediately blows again.
2
3
4
1. Electrical cover
2. Fuse holder
3. Fuse (20 A × 3, 30 A, 100 A × 2)
4. Spare fuse (20 A, 30 A, 100 A)
5. Fuse puller
3
1
3
ZMU01903
Trouble Recovery
1. Fuse (20 A × 3, 30 A, 100 A × 2)
2. Fuse puller
EMU29522
Power trim and tilt / power tilt will not
operate
If the engine cannot be tilted up or down with
the power trim and tilt / the power tilt because
of a discharged battery or a failure with the
power trim and tilt unit / the power tilt unit, the
engine can be tilted manually.
1.
Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
5
4
1
1. Manual valve screw
2.
Put the engine in the desired position,
then tighten the manual valve screw by
turning it clockwise.
2
1
ZMU01904
ZMU01905
77