Fuel Consumption Meter; Fuel Economy - Yamaha Z300 Owner's Manual

Basic components
1. Selector switch
The fuel consumption meter and fuel
G
economy meter will indicate the same unit
of measurement.
EMU26760

Fuel consumption meter

This gauge displays the total amount of fuel
consumed since the gauge was last reset.
Press the " " (mode) button repeatedly
until the indicator on the face of the gauge
points to total "
fuel consumption to zero, press the "
(set) and " " (mode) buttons at the same
time.
EMU26770

Fuel economy

This gauge displays the distance per liter or
gallon when cruising, and is only for refer-
ence use by the operator.
Press the " " (mode) button repeatedly
26
" (total). To reset the total
ZMU01751
until the indicator on the face of the gauge
points to "
NOTE:
If twin engines are installed on your boat, the
gauge will only display the total fuel economy
of both engines.
NOTE:
Fuel consumption varies greatly with boat
G
design, weight, propeller used, engine trim
angle, sea conditions (including wind), and
throttle position. Fuel consumption also
varies slightly with the type of water (salt,
"
fresh, and contaminate levels), air temper-
ature and humidity, cleanliness of the boat
bottom, engine mounting height, skill of
the operator, and individual gasoline for-
mulation (winter or summer fuel and
amount of additives).
The Yamaha digital speedometer and fuel
G
management meter calculates speed,
miles traveled, and fuel economy by water
movement at the stern of the boat. This
distance can vary greatly from the actual
distance traveled because of water cur-
rents, sea swells, and the condition of the
water speed sensor (partially plugged or
damaged).
Individual engines may slightly vary in their
G
fuel consumption due to manufacturing
variations. These variations can be even
" (economy).
ZMU01752