Yamaha XT225V Owner's Manual page 75

the brake rod from the brake cam-
shaft lever.
3 (a)
1
5
1. Brake pedal free play adjusting nut
2. Brake rod
3. Brake camshaft lever
4. Axle nut
5. Chain adjusting plate
3. Loosen the axle nut.
4. Turn the drive chain adjusting
plate on each side of the swingarm
fully in direction (a).
5. Lift the rear wheel off the ground
according to the procedure on
page 6-36.
6. Remove the axle nut.
7. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
PERIODIC MAINTENANCE AND MINOR REPAIR
4
2
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
8. Pull the wheel axle out, and then
remove the wheel.
To install the rear wheel
1. Insert the wheel axle from the
left-hand side.
1. Retainer
NOTE:
Make sure that the drive chain adjust-
ing plates are installed with the
punched sides facing to the outside
and that the slot in the brake shoe plate
fits over the retainer on the swingarm.
EAU25791
6-39
2. Install the drive chain onto the rear
sprocket, and then adjust the drive
chain slack. (See page 6-26.)
3. Install the axle nut, and then lower
the rear wheel so that it is on the
ground.
4. Tighten the axle nut to the speci-
fied torque.
1
2
3
4
5
6
7
8
9