Yamaha YZF-R7 Owner's Service Manual page 149

b b
a a
CAMSHAFTS
7. Check:
• TDC mark a
Make sure that the TDC mark is
aligned with the crankcase mating sur-
face b.
• camshaft punch mark c
Make sure that the camshaft punch
mark is aligned with the arrow mark d
on the camshaft cap.
Out of alignment
Refer to the installation steps above.
8. Measure:
• valve clearance
Out of specification
Refer to "ADJUSTING THE VALVE
CLEARANCE" in chapter 3.
9. Install:
• cylinder head cover gasket
• cylinder head cover
NOTE:
• Apply bond TB1541 onto the mating
surfaces of the cylinder head cover
and cylinder head cover gasket.
• Apply bond 1215B onto the mating
surfaces of the cylinder head cover
gasket and cylinder head.
• Tighten the cylinder head cover bolts
in stages and in a crisscross pattern.
4 - 17
ENG
Adjust.
Adjust.