Yamaha Diversion 900 Owner's Manual page 75

To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
2. Lift the wheel up between the fork
legs.
NOTE:
@
Make sure that the slot in the speedom-
eter gear unit fits over the retainer on
the fork leg.
@
3. Insert the wheel axle.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Retainer
4. Take the motorcycle off the cen-
EAU03420
terstand so that the front wheel is
on the ground.
5. Install the brake calipers by install-
ing the bolts.
NOTE:
@
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
@
6. Tighten the front wheel axle pinch
bolt, then the wheel axle, and the
brake caliper bolts to the specified
torques.
7. Connect the speedometer cable.
8. Push down hard on the handlebar
6-32
Tightening torques:
Wheel axle:
59 Nm (5.9 m·kg)
Front wheel axle pinch bolt:
19 Nm (1.9 m·kg)
Brake caliper bolt:
40 Nm (4.0 m·kg)
several times to check for proper
fork operation.
6