Adjusting The Rear Brake Light Switch; Checking The Front And Rear Brake Pads - Yamaha Diversion 900 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Brake light switch
2. Brake light switch adjusting nut
Adjusting the rear brake light
switch
The rear brake light switch, which is ac-
6
tivated by the brake pedal, is properly
adjusted when the brake light comes
on just before braking takes effect. If
necessary, adjust the brake light switch
as follows.
Turn the adjusting nut while holding the
rear brake light switch in place. To
make the brake light come on earlier,
turn the adjusting nut in direction a. To
make the brake light come on later,
turn the adjusting nut in direction b.
Front
1. Brake pad wear indicator groove ( 6)
Checking the front and rear
EAU00713
brake pads
The front and rear brake pads must be
checked for wear at the intervals spec-
ified in the periodic maintenance and
lubrication chart. Each brake pad is
provided with wear indicator grooves,
which allow you to check the brake pad
wear without having to disassemble the
brake. If a brake pad has worn to the
point that the wear indicator grooves
have almost disappeared, have a
Yamaha dealer replace the brake pads
as a set.
Rear
1. Brake pad wear indicator groove ( 2)
EAU01160
6-21