Handset / Handsfree / Headset; Programmable Keys; Line - Snom 220 Manual

Basic Functions

Handset / Handsfree / Headset

The snom220 supports calls being made while using the handset or the
handsfree capability. During a call it is possible to switch between both
modes by pressing the function keys
If a headset is connected and the audio output is set to headset ("RJ
Conn" or "Chinch"), the snom220 will treat the headset as the output
device for calls. When the snom 220 is used in a call center environment
the connected headset will be the default setting for speaking on the
phone. The ENTER key
Key mapping:
ENTER
CANCEL

Programmable Keys

The five keys to the right of the numbers block are the programmable
function keys that have the following options:
•
•
•
•
•
•
Each of these buttons has an LED indicating the status of the respective
programmable key at any given time.
Some features are common to all keys:
Pressing a key when its LED is blinking and the phone is ringing will
receive the call.
Pressing the key when a call is in progress at that key as indicated by
the constantly lighted LED, will put the call on hold.
Pressing a key while editing a number for dialing at that key will erase
the number and the phone will go to idle state.
Each of these different options will now be explained in detail.

Line

'Line' can be used in one of the following ways:
22
on the right side beside the display.
Switch to handsfree mode and back.
/
Accept incoming calls in headset mode.
Returns the phone to the idle state.
Line
Destination
Intercom
Park Orbit
Voice Recorder
DTMF (H323 only)
/
is therefore used to accept incoming calls.
or the Speaker key