Table of Contents
Advertisement
HEADSET OPERATION
Your VTech cordless phone is equipped with a 2.5mm headset Jack for use with an optional
accessory Headset for hands-free operation.
If you choose to use the Headset option, you must obtain an optional accessory Headset,
which is compatible with the VTech cordless phone.
To purchase a Headset, call VTech Customer Service at 1-800-595-9511.
In Canada, call VTECH Electronics at 1-800-267-7377.
Once you have a compatible 2.5mm Headset, locate the Headset Jack on the VTech cordless
phone Handset. Connect the plug on the Headset cord to the jack on the cordless Handset.
The plug should fit securely. Do not force the connection.
OPERATION
NOTE: Whenever a compatible Headset is connected
to the cordless Handset, the microphone on the Handset
will be muted. This is done to limit the effect of back-
ground noise.
The following operational characteristics also apply to
other headsets which are not sold by VTech; however,
VTech assumes no responsibility for their performance.
The VTech compatible Headset has a reversible, mon-
aural design. You can wear you Headset on either ear,
leaving one ear free for room conversation.
The headband can be adjusted to fit the contour of you
head. Using both hands, slide the headband up or down
so that it rests comfortably on your head, with the speaker
cushion centered against your ear.
For maximum sound quality, the flexible microphone should be
positioned at the corner of your mouth, about one inch from your
face.
BELT CLIP
The VTech cordless phone is also equipped with a detachable
belt clip. Align the pins on the inside edge of the clip with the
notches on the sides of the VTech cordless phone Handset. The
belt clip should snap securely into place.Do not force the con-
nection.
19
Advertisement
Table of Contents
