VTech VT 2961 Manual page 22

ANSWERING SYSTEM SETUP
Day and Time
During initial setup, or after a power failure, the day and time default is set to Monday,
12:00am. The display will flash "CL" to indicate day and time need to be set.
ANSWER
MEMO ANSWER ON/OFF
SELECT
TIME/SET MENU
MENU
DELETE
SPARE
CHARGING BATTERY NEW CALL
3
1 2
MAIL BOX
PLAY/STOP
REPEAT SKIP
VOLUME
MUTE INTERCOM
CONF HOLD FLASH
LINE 1 OFF LINE 2
MIC
Set Audible Message Alert
If you want your Answering System to beep once every 10 seconds to notify you when
new messages have been received, set Audible Message Alert to ON. Otherwise, it is
preset to OFF.
ANSWER
MEMO ANSWER ON/OFF
TIME/SET SELECT MENU
MENU
DELETE
SPARE
NEW CALL
CHARGING BATTERY
1 2 3
MAIL BOX
PLAY/STOP
REPEAT SKIP
VOLUME
MUTE INTERCOM
CONF HOLD FLASH
LINE 1 OFF LINE 2
MIC
1. Press MENU unit you hear, "Set day and
time."
2. Press SELECT until the correct day is
Set Day & Time
announced.
MENU
3. Press TIME/SET to confirm your choice.
4. Press SELECT until the correct hour is
SELECT
announced.
5. Press TIME/SET to confirm your choice.
TIME/SET
6. Press SELECT until the correct minute is
announced. Holding the key continuously
SELECT
will increase the minutes by 10 minute steps.
7. Press TIME/SET to confirm your choice. You
TIME/SET
will hear an announcement of the day and
time.
1. Press MENU until you hear "Set Audible
Message Alert."
Set Audible
2. Press SELECT until the desired setting, (ON
Message Alert
or OFF) is announced.
MENU
3. Press TIME/SET to confirm your choice.
The voice prompt of "Audible Message Alert
SELECT
On" or "Audible Message Alert Off" will be
heard.
TIME/SET
22