Placing The Dishwasher - Kenmore Dishwasher Installation Instructions Manual

PLACING THE DISHWASHER

1) Straighten and position the hot water supply line and
the electrical supply cable as shown in Figure 14 so
Hot Water
that they will align with their channels under the
Supply Line
dishwasher base.
2) Position the dishwasher close enough to the
Electrical
14"
enclosure so that you can run the dishwasher drain
Supply
(355mm)
hose to the under-sink drain connection. Make certain
Cable
that the hot water supply line and the electrical supply
21"
cable are in their channels under the dishwasher base, (533mm)
as shown in Figure 15, letter A.
3) Place the dishwasher directly in front of the enclo-
sure.
Figure 14
4) Perform a level check as shown in Figure 15. Adjust
the rear leveler by turning the center screw at the front
of the dishwasher, as shown in Figure 16, letter B.
Turning the screw clockwise raises the rear of the
dishwasher. Adjust the front levelers by turning them
with a screwdriver, as shown in Figure 16, letter C.
Turning the levelers to the right raises the dishwasher.
If additional height is needed, shims may be added
under the leveler feet.
5) Push the dishwasher into the enclosure.
A
Figure 15
B
C
Figure 16
9
Placing the Dishwasher