Electrical Connection - Kenmore Dishwasher Installation Instructions Manual

Elite
Hide thumbs Also See for Dishwasher:
Table of Contents

Advertisement

Available languages

Available languages

ELECTRICAL CONNECTION

WARNING: ELECTRICAL
SHOCK HAZARD - Working on an
energized circuit could result in serious
injury or death. Only qualified electri-
cians should perform electrical work.
Do not attempt any work on the dish-
washer electric supply circuit until you
are certain the circuit is de-energized.
WARNING: FIRE HAZARD -
Improper electrical work can cause fire.
Only qualified electricians should
perform electrical work.
Grounding Instructions
The dishwasher must be properly grounded before
operating. This appliance must be connected to a
grounded metal permanent wiring system, or an
equipment grounding conductor must be run with the
circuit conductors and connected to the equipment
grounding terminal or lead on the dishwasher. Make
sure that the dishwasher is connected to a suitable
ground in compliance with all local codes or, in the
absence of a local code, with the NATIONAL ELECTRI-
CAL CODE in the United States or the CANADIAN
ELECTRIC CODE C22.1-latest edition in Canada as
well as any provincial/state or municipal or local codes
that apply.
1) Retrieve the strain relief plate, and install a strain
relief (not supplied) into the opening on the strain relief
plate. NOTE: Orient the strain relief as shown in Figure
26.
2) Pass the electrical supply cable through the strain
relief, as shown in Figure 27. Leave 3 - 4 inches of
insulated wire extending through the strain relief plate.
3) Tighten the strain relief screws.
4) Slide the strain relief plate into the junction box, and
secure it to the junction box with the supplied screw.
(Continued on next page)
12
Electrical Connection
Figure 26
Figure 27

Advertisement

Chapters

Table of Contents
loading

Table of Contents