Installing The Configuration Files - Cisco IP Phones Installation And Configuration Manual

Installing the Configuration Files

Included with this technical note is a folder containing configuration files and templates used by the UC
server to automatically detect and provision Cisco 79x0 Series telephones. This folder must be copied into
the UC server folder tree (along with the Cisco SIP firmware files as outlined above in
Firmware Upgrades on page
To install the configuration files:
1. Extract the Cisco folder from the .zip file titled Cisco (7940, 7960) Installation and Configuration
(P0S3-08-9-00) (located in the same directory as this document) and copy it under the
PhoneTypes folder located here:
X:\Program Files\ADTRAN\NetVanta UC Server\Data\System\PhoneTypes, where X is the
drive where the UC server program files are installed.
For example, the resultant path after the folder is copied (henceforth known as the Cisco
PhoneTypes folder) might appear as follows:
C:\Program Files\ADTRAN\NetVanta UC Server\Data\System\PhoneTypes\Cisco
2. Copy the Cisco SIP firmware files (as outlined in
the Cisco PhoneTypes folder.
CAUTION: Cisco phones will not automatically upgrade to the correct version if the firmware files
are not copied into the above folder. Failing to upgrade the phones to the correct version may result
in unexpected behavior and/or a loss of functionality.
3. Restart the NetVanta UC Server Application Service.
Select Start > Control Panel > Administrative Tools > Services.
Scroll down and select NetVanta UC Server Application Services.
Right-click the entry and select Restart.
1).
2
Obtaining Firmware Upgrades on page
Obtaining
1) into