Control Panel; System Cooling - Supero SUPERSERVER 6016T-GTF User Manual

S S
UPER ERVER 6016T-GTF/GIBXF/GIBQF User's Manual
Figure 6-1. Chassis: Front and Rear Views
Power Supply
USB Ports
PCI Slot
*The Infi niBand port is included on the 6016T-GIBXF/GIBQF only.
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Installation."
6-3

System Cooling

Four 4-cm counter-rotating fans provide the cooling for the system. Each fan unit
is actually made up of two fans joined back-to-back, which rotate in opposite di-
rections. This counter-rotating action generates exceptional airfl ow and works to
dampen vibration levels.
It is very important that the chassis top cover is properly installed and making a
good seal in order for the cooling air to circulate properly through the chassis and
cool the components. See Figure 6-2.
Hot-Swap Drive Bays (3)
Dedicated IPMI LAN Port
LAN Ports COM Port VGA Port
6-2
Control Panel
Infi niBand Port*