Using The Smart Card Reader (Optional) - Motion Computing J3500 User Manual

Camera tips
•
Hold the camera steady and allow it to focus.
•
If your pen is tethered, ensure that the tether is not in front of the camera lens.
•
Ensure you have adequate lighting.
•
You can use the Pictures window to take and review multiple pictures. Use the slider bar
at the bottom of the Pictures window to switch among active pictures.

Using the smart card reader (optional)

Some Tablet PCs contain the optional smart card reader. Using smart card software, this
device reads information from the smart card when the card is inserted into the reader.
Depending on the smart card software you are using:
•
You may receive an acknowledgement for when the smart card is fully engaged in the
reader.
•
You may receive a prompt or be required to shut down the software before removing the
smart card.
•
Some smart cards may require you to insert the smart card for authentication, and then
remove the smart card when authentication is completed.
•
Some smart cards may require keeping the card in the reader while the smart card
software is running.
To insert the smart card
1. Remove the card slots cover.
2. Slide the smart card into the slot, with the metal contacts of the embedded chip facing
the top of the Tablet PC, until the card is firmly seated in the reader.
To remove the smart card
Depending on your smart card software, you may need to shut down the smart card
software before removing the card. With this type of software, removing the smart card
while the Tablet PC is running can result in logging off or shutting down the Tablet PC.
•
Pull the card straight out of the reader and replace the card slots cover.
Chapter 3 Using your Tablet PC
Smart card reader slot (cover removed)
33