Table of Contents
Advertisement
Level 2.
Tools required:
Screwdriver, Tachometer (ECHO P/N 99051130017)
Parts required:
None
NOTE
Every unit is run at the factory and the carburetor is set in compli-
ance with emission regulations. Carburetor adjustments, other
than idle speed, must be performed by an authorized ECHO
dealer.
1.
Check idle speed and reset if necessary. If a tachometer is avail-
able, idle speed screw (A) should be set to the specifications found
on page 25 "Specifications" of this manual. Turn idle screw (A)
clockwise to increase idle speed; counter clockwise to decrease
idle speed.
warning
When carburetor adjustment is completed, the cutting attachment
should not turn at idle, otherwise serious personal injury may
result.
drIve shaft lubrIcatIon
Level 1.
Tools required:
8 mm Open End Wrench, 4 mm Hex Wrench,
Clean rag
Parts Required: POWER BLENDX
Base Grease.
1.
Loosen two (2) screws (A) and remove center locating screw (B).
Pull gear box and shield from drive shaft housing.
2. Pull flexible cable from the drive shaft housing, wipe clean and
recoat with a thin coating [15 ml (1/2 oz.)] of grease.
3. Slide the flexible cable back in the drive housing. DO NOT get
dirt on the flex cable.
4. Install the gear housing and shield assembly.
8 oz. (P/N 91014) or Lithium
TM
P
e
ower
o
'
M
Perator
s
a
a
B
21
dger
anual
Advertisement
Table of Contents
