Assembly; Changing The Diamonds; Connect The Vacuum Cleaner; Transport - Husqvarna PG 400SF Operator's Manual

Changing the diamonds

Shut down the machine and disconnect the power plug.
Have a set of gloves ready, as diamond tools can get very hot.
1 Crank up the handlebar to the highest position.
2 Pull back on handle to lift grinding head off the ground.
3 Lay machine back on the ground.
4 Put on gloves.
5 Use a rubber hammer/mallet to remove the diamond
segments.
6 Affix new diamond segments on the grinding disc.
7 Once new diamond segments have been attached,
reverse procedure to lower machine to ground.
8 –
English

ASSEMBLY

Connect the vacuum cleaner

Connect the vacuum cleaner to the machine.
It is highly recommended to use the Husqvarna DC 3300 dust
extraction system for complete dust control.
Make sure that the filters in the vacuum cleaner are intact and
clean. Pay attention to dust during operation.

Transport

The machine can be folded to minimize space needed for
transport.
8 Loosen the screws and the lock handle that hold the cover
in place.
1 Place the crank with the handle pointing straight upwards.
2 Remove the cover.
3 Carefully fold the machine forward.
4 The cover can be attached to the side of the machine.