Husqvarna K960 Ring Operator's Manual page 14

• Fit the blade.
CAUTION! The blade has a groove (A) on one side that
acts a the guide groove for the support rollers. Ensure that
the V-shaped edge of the blade enters the drive wheel and
that the blade's guide groove fits in the guide rollers. Also
see under the heading Drive.
• Press in the guide roller if necessary, so that it climbs into
the groove on the blade.
• Fit the support roller cover. Now tighten the four screws
fully.
• Rotate the blade and make sure that the support rollers
are not clamped against the blade.
• Adjust the adjuster screws so that the support rollers
make contact against the blade.
14 –
English
SETTINGS AND ADJUSTMENTS
• Adjust so you can easily stop the support rollers using
your thumb when the blade is rotated. The support rollers
should only follow the blade occasionally.
• Tighten the locking nuts on the support roller guard.
• Rotate the blade and make sure you can still hold the
rollers with your thumb when the blade is rotated.
CAUTION! The machine shall stand upright when
checking the roll pressure. If the machine lies on its side
the weight of the blade makes it difficult to make a correct
adjustment.
• Tighten the knobs fully and the machine is ready to use.