Setting The Self-Clean Mode - Smeg Built-in oven Use & Installation Manual

ENGLISH
Use & Installation Manual

Setting the Self-Clean Mode

To Set the Self-Clean Mode
1. Touch [UPPER/LOWER] key to select
the cavity to be cleaned, if the oven is a
double.
2. Rotate both knobs into the clean
position.
3. CLEAN & TIME appear.
4. The clean
automatically, its standard value is 3
hours.
5. At the end of the programmed cleaning
time, the oven will automatically turn off.
6. To stop the cleaning mode at any
moment, move one of the two knobs
from the cleaning position.
Do not attempt to open the door while the door
is locked. The "AUTO LOCK" writings will flash
until the motor stops. When they are displayed,
the door cannot be opened. Check that the
door has been locked and will not open before
starting the Self-Clean mode.
If door does not lock, rotate the cooking mode
knob into the OFF position and do not start self-
clean; phone for service.
If the door is in the open position when this
mode is selected, the "AUTO LOCK" writings
will flash until the door is closed. The latch
doesn't move.
To Change the Cleaning Time
1. To change the setting from 3 hours,
select either 2 hours for light soil or 4
hours for heavy soil immediately before
starting.
2. To change the hours, touch the [TIME]
key.
3. The hours will flash.
4. Use [INC] or [DEC] keys to change the
value.
28
time is displayed
5. To change the minutes, touch the
[TIME] key again.
6. The minutes will flash.
7. Use [INC] or [DEC] keys to change the
value. Hold the key to change by 10
minutes steps.
8. Touch [TIME] or wait a few seconds to
confirm the new value.
To Delay the Start of Cleaning
1. Follow steps 1 through 7 above.
2. Touch the [TIME] key and verify that
"STOP TIME" appears on the display.
The hours will begin flashing.
3. Use [INC] or [DEC] keys to change the
stop time value.
4. To change the minutes, touch the [TIME]
key, the minutes will flash.
5. Use [INC] or [DEC] keys to change the
value. Hold the key to change by 10
minutes steps.
6. Touch [TIME] or wait a few seconds to
confirm the new value.
7. The latch starts moving to lock the oven
door, the display shows "DELAY".
8. When the delay time expires, self-
cleaning will start.
9. At the end of the programmed cleaning
time, the oven will automatically turn off.
10. "End" will appear on the temperature
display, "CLEAN" on the mode display
and "TIME" on the clock display will start
flashing until the [TIME] key is touched or
the knob is moved to the OFF position.
In order to check the cleaning or the stop time
during a delayed clean, simply touch the [TIME]
key until "TIME" or "STOP TIME" writings are
displayed.
28
Use & Installation Manual