Table of Contents
Advertisement
Installation
Levelling the appliance
The appliance must be perfectly level
to ensure safe and proper operation.
^ The screw feet can be adjusted to
compensate for any unevenness in
the floor.
,
Do not block the gap between
the bottom of the tumble dryer and
the floor with plinth facings, deep
pile carpet etc. This would hinder a
sufficient flow of air to the dryer.
56
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out if the tumble dryer is tipped up
when it is being moved. It is a good
idea to run the Cool air programme for
approximately 1 minute before moving
it. Any remaining condensed water will
then be fed into the condensed water
container or out through the drain hose.
Washer-dryer stack
The tumble dryer can also be
combined with a Miele washing
machine in a washer-dryer stack. The
appropriate "WTV" stacking kit* to
match your dryer is required.
* Miele accessory available to order
,
Stacking kits must only be
installed by a suitably qualified fitter.
Hide quick links:
Advertisement
Table of Contents
