Notes On The Built-In Clock; Selecting The Clock Mode - A&D UA-767NFC Instruction Manual

Notes on the Built-in Clock

The monitor displays the clock as long as power is connected.
Adjust the clock prior to use.
The current clock setting will be cleared if the batteries are removed, or
power is not connected for approximately 30 seconds while the AC
adapter is used. In this case, adjust the clock again.
When adjusting the clock, press the
one, or press and hold the
The setting procedure cannot be reversed. If the wrong value is set, start
the setting procedure again.
After 30 seconds of non-operation, the setting procedure will be
automatically canceled.
To cancel the operation anytime, press the START button.
During measurement, the clock adjustment is not available.

Selecting the Clock Mode

Two clock modes are available, 12-hour clock or 24-hour clock.
1. Press and hold the
until the year starts blinking.
2. Press and hold the
"12H" appears on the display.
3. Press the
between "12H" and "24H".
4. Press the
the clock in the selected mode.
Using the Monitor
button
button.
button to switch
button to display
button to increase the value by
button to change the value continuously.
Press and hold
Press and hold
Press
8
24-hour
12-hour
clock
clock