Adjusting The Built-In Clock - A&D Life Source UA-767FAM Instruction Manual

Adjusting the Built-in Clock

Adjust the clock prior to use.
1. Press and hold the SET button until the
year starts blinking.
2. Select the year using the
Press the SET button to set the current
year and move to month/day selection. The
date can be set anywhere between the
years 2010 and 2059.
3. Select the month using the
button.
Press the SET button to set the current
month and move to day selection.
4. Select the day using the
Press the SET button to set the current
day and move to hour/minute selection.
5. Select the hour using the
Press the SET button to set the current
hour and move to minute selection.
6. Select the minute using the
button.
Press the START or SET button to turn the
device off.
Holding down the
the value continuously.
Note: After three minutes of non-operation, the device
will turn off automatically.
When the clock has not been
set, the clock display indicates
dashes as shown to the right.
When you use the device for the first time, change
batteries or use AC Adapter, the setting date and
time is reset after approx. 30 seconds the power
source is unconnected. If the setting date is reset,
please setup again.
Using the Monitor
or button.
or button.
or button.
or button will change
English 10
Press and hold
or
or
or
Minute
or
Year
Month
Day
Hour
or
START
Turn off
or
or
or