Finishing Edges; Metal Cutting; Plastic Base Plate; Anti-Splintering Device - Makita 4304T Instruction Manual

Finishing edges
To
trim
edges
or
make slight dimensional
adjustments, run the blade lightly along the
cut edges.
/ /
Metal cutting
Always use a suitable coolant (cutting oil) when cutting metal. Failure to do so will cause
significant blade wear. The underside of the workpiece can be greased instead of using a
coolant.
Plastic base plate
Use the plastic base plate when cutting de-
corative veneers, plastics, etc. l
t
protects
sensitive or delicate surfaces from damage.
To replace the base plate, remove the four
screws.
Anti-splintering device
To reduce the potential for workpiece
surface splintering, the anti-splintering
device can be used. Fit
it
into the base
from below so
that it surrounds the sides
of the blade.
Screw
ic
base plate
I
ase
Anti-splintering device
ef
10